How to apply edgebanding

Best used on flat or cylindrical surfaces.

1. Prepare Surface Edge

Fill any large holes
Sand rough spots
Remove sawdust
Cut edging 1/2" longer than surface to be covered

2. Apply Edging

Preheat iron on “cotton” setting
Position edging
Slowly press iron over edging
Check to see if glue is melting
NOTE: Use kraft paper or aluminum foil to protect iron bottom.

3. Bonding

While still hot, press veneer down firmly with wood block or roller
Mistake? Simply reheat and reapply

4. Trim Edge

Allow edging to cool completely
Trim any excess with an Edge Trimmer, a razor blade or file
Sand smooth and finish as desired